Top Features:
 
Only 1.575 inches x 0.39 inches (40 mm x 10 mm)
8 LED's
Integrated current limiting resistors
Protection against reverse polarity
Working voltage from 3.3 volts to 12 volts
 
Are you fed up of fitting LEDs and current-limiting resistors time after time into your breadboard? 
It's surprising how often you have to do it, and how much room they take up. Well, this tiny little module is the answer.
 
No more bundles of wires and mounds of resistors filling up your breadboard! Imagine wiring up the LED's in the movie below using discrete components!  It would be a nightmare and take ages. That layout took just momentsusing the Rapid Prototyping LED modules!

Ideal for linking up to your Arduino (Atmel® AVR microcontrollersArduino version "Mini","Nano","Extreme", "Mega", "Mega2560","Duemilanove" etc), PIC (Microchip PIC® Microcontrollers (MCUs), range 8-bit, 16-bit and 32-bit Microcontrollers), arm processor like Raspberry Pi, BeagleBoard, etc, and can even plug direct into the headers with a single trailing ground lead to the common cathode connection.

Specifications:
 
Output Board
Ideal for testing outputs and using for status indication. 8 small LED's (3mm), with current limiting resistor, ready to operate with +5V input. 
Can be connected directly to output port of control board, training board etc. 
 
This module intended for educational, experimental and production purposes with 8 led's
Power Supply Voltage: 3.3-12V
Peak Led Output Current (maximum): 20mA for each led
Peak Total Output Current (maximum): 160mA for 8 led's
 
Power Supply Voltage 3,3v 5v 9v 12V
Peak Led Output Current (Typical each led) ~1mA ~2mA ~5mA ~8mA
Peak Total Output Current (Typical 8 led's) ~8mA ~16mA ~40mA ~64mA
 
Connects Directly to Others Controller Boards
Easily Test Outputs with LED Status Indication of each Port Pin
Separate Power Supply is Not Required
Easily Adaptable to use with Other Boards
Standard 1x10 2.54mm Pin Socket
Protection against reverse polarity (two diodes)
Operating Temperature: -40 to 85 ºC
Interface: 8 leds output
Hole Pitch: Approx. 40mm and 35mm
Hole Inner Diameter: Approx. 2.5mm
Board Size (L x W): 40 x 10mm
Weight: 3g
 

Write a review

Note: HTML is not translated!
    Bad           Good

Rapid Prototyping LED Module (Bargraph - 4 green, 2 yellow and 2 red) (Size S)

  • Product Code: ModuleLED_S
  • Availability: In Stock
  • 4.99€


  • 3 or more 4.89€
  • 5 or more 4.79€

Tags: Module

www.000webhost.com